This is a working overview of Bremelanotide, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2025-10-15. Anything still debated is marked as such rather than presented as settled.
Lyophilised peptide is generally held below minus twenty degrees Celsius, protected from light and moisture, because hydrolysis and oxidation accumulate faster at ambient temperature. Once reconstituted, solutions are typically kept between two and eight degrees Celsius and used within a short window defined by the supplier. Repeated freeze-thaw cycles are avoided since they promote aggregation and loss of soluble material. Container material matters as well, because peptides adsorb to certain plastics and glass surfaces at low concentration. Stability figures supplied by a vendor apply only to the specific lot and buffer that were tested.
Identity and purity are usually established with reversed-phase high-performance liquid chromatography combined with mass spectrometry. A gradient of water and acetonitrile containing trifluoroacetic acid is a common mobile phase, and ultraviolet detection near 214 nanometres responds to the peptide backbone. Mass spectrometry confirms the expected molecular mass and helps reveal truncation or oxidation products. Purity is reported as a peak-area percentage, a figure that depends on the wavelength and gradient used, so values from different laboratories are not always directly comparable. Peptide mapping and amino acid analysis provide additional confirmation when required.
Regulatory status varies by jurisdiction, where approved prescription products, compounded preparations and research-grade material are treated as distinct categories with different documentation requirements. Suppliers of research material commonly issue a certificate of analysis listing purity, identity and sometimes endotoxin content. Independent verification by a third-party laboratory is often recommended because self-reported figures are difficult to check. Literature discussions usually state the source, purity and storage conditions of the material used, since these details affect reproducibility. Analysts note that a reported purity figure does not by itself describe biological activity.
PT-141 is the research designation for bremelanotide, a synthetic cyclic heptapeptide developed as a melanocortin receptor agonist. The peptide contains seven amino acids with an internal lactam bridge that constrains the backbone into a stable ring. Cyclisation of this kind improves resistance to enzymatic degradation relative to linear analogues. The compound was first explored for effects on melanin production, because several melanocortin receptors influence pigmentation. Its later association with sexual desire emerged from observations made during that early work, and the molecule became the subject of a separate development programme.
Bremelanotide is a moderately large peptide with a molecular mass near 1025 daltons. In lyophilised form it appears as a white to off-white powder and is freely soluble in water and other polar solvents. The intact lactam ring is essential for receptor affinity, while linearised fragments bind far more weakly. Solutions are sensitive to extremes of pH and to prolonged exposure to light and heat, so handling typically involves buffered conditions and cold storage. Its short plasma half-life reflects rapid distribution and clearance rather than chemical breakdown inside the vial.
Development of the peptide passed through several delivery formats, including an intranasal version tested in early trials and an injectable version that entered later clinical study. Regulatory approval for a subcutaneous product in the United States was granted in 2019 after review of controlled trials in premenopausal women. Outside the clinic, the compound circulates in research and non-pharmaceutical markets under its code name, where identity and purity vary considerably between suppliers. Synonyms appearing across technical literature include bremelanotide, PT-141, and Palatin 141.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised solid before reconstitution |
| Solubility class | Soluble in water and aqueous buffers | Stock solutions often prepared in sterile water |
| Typical storage temperature | Minus twenty degrees Celsius or below | Dry powder, protected from light |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Ultraviolet detection near 214 nanometres |
| Common synonyms | PT-141 and bremelanotide | Code and generic name used interchangeably |
Lyophilized peptide material is generally stored at -20 °C or below to limit degradation, while reconstituted solutions are less stable and are typically kept refrigerated and protected from light. Repeated freeze-thaw cycles can accelerate aggregation and should be minimized. Stability for any specific lot depends on purity, moisture content, and packaging. Handling in a temperature-controlled environment reduces variability across replicates, and exposure to ambient humidity during weighing can introduce error. Aliquotting reduces the number of times a stock container is opened.
Reverse-phase high-performance liquid chromatography is the standard method for assessing purity. Mass spectrometry confirms molecular identity and detects sequence variants or truncation products. Ultraviolet absorbance at 214 or 280 nm is used for quantification, with the choice depending on the peptide sequence. Method validation typically addresses linearity, limit of detection, and precision across a defined concentration range. Impurity profiling may also employ ion-exchange or size-exclusion chromatography, and these techniques complement one another.
PT-141 initiates cellular signaling by binding to specific subtypes within the melanocortin receptor family. These receptors belong to the G protein-coupled receptor superfamily, and activation raises intracellular cyclic adenosine monophosphate levels. This cascade ultimately influences neuronal circuits in the central nervous system that are associated with sexual desire and arousal. Research indicates the compound's action concentrates in hypothalamic regions rather than peripheral tissues, which helps explain some observed pharmacological features. The selectivity of receptor binding underlies its functional differences.
Compared with the related compound melanotan II, PT-141 shows markedly weaker activation of receptors tied to pigmentation. This difference stems from subtle structural variations that alter affinity distribution across receptor subtypes. Investigators propose that such selectivity produces a different side effect profile in specific applications. However, downstream consequences of prolonged receptor activation remain uncertain in the literature. Published studies do not fully agree on the duration of signaling pathway activity and the mechanisms of desensitization.
Whey Protein: 96 Whole Soy Bean: 96 Human milk: 95 Chicken egg: 94 Soybean milk: 91 Buckwheat: 90+ Cow milk: 90 Cheese: 84 Quinoa: 83 Rice: 83 Defatted soy flour: 81 Fish: 76 Beef: 74 Immature bean: 65 Full-fat soy flour: 64 Soybean curd (tofu): 64 Whole wheat: 64 White flour: 41 Common foodstuffs and their values: (Note: These values use "whole egg" as a value of 100, so foodstuffs that provide even more nitrogen than whole eggs, can have a value of more than 100. 100, does not mean that 100% of the nitrogen in the food is incorporated into the body, and not excreted, as in other charts.)
=== Sport === Paul Frère (1917–2008), Belgian racing driver Wilfried Nancy (born 1977), football manager Jérôme Le Banner (born 1972), kickboxer and K-1 fighter Vikash Dhorasoo, (born 1973), international footballer Olivier Davidas (born 1981), footballer Dimitri Dragin (born 1984), judoka Julien Faubert (born 1983), footballer Kevin Anin (born 1986), footballer Gueïda Fofana (born 1991), footballer Jaylen Hoard (born 1999), French-American basketball player for Hapoel Tel Aviv Dan Delaunay (born 1995), professional footballer.
== Limitations == Despite its aforementioned advantages as a specialized tool, the B1H system does have some drawbacks. First, the B1H selection system is limited in its capacity to determine the binding specificities of transcription factors with lengthy binding sites. This arises from the fact that the number of randomized “prey” clones required to represent all possible target sequences increases exponentially with the number of nucleotides in that target sequence. Second, some eukaryotic factors may not express or fold efficiently in the bacterial system, attributed to differing regulatory networks and transcriptional machinery. Hence when working with DNA-binding proteins of eukaryotic origin, a yeast-based hybrid system may be beneficial. Third, the B1H system may not be ideally suited for transcription factors that recognize binding sites with low affinity. The logic here is that competition created by binding sites elsewhere in the bacterial genome may limit the signal that can be realized from a single binding site that is present upstream of the reporter.
Sources: en.wikipedia.org
By interchanging the Arg-1, Lys-3, and Asp-8 residues to see if their positions are essential for sodium channel binding or formation of the secondary structure, inactive peptides were obtained which proposes that correct positioning of these residues is critical for activity. The introduction of disulfide bonds in the kink structure to make it less flexible also led to inactive peptides as they appeared to be very sensitive to structural changes. However, a peptide where Lys-3 was replaced with a more basic Arg residue showed better activity. This was designed based on observations that some of the acidic residues in the neuronal sodium channels are important for binding and that removal of basic residue Lys-3 from α-PMTX was not tolerated, while removal of acidic residue Asp-8 was. By combining K3R (lysine-3 to arginine) and S11L (serine-11 to leucine) mutations, a higher activity could also be obtained. Lipophilic residues in other toxins that block sodium channels have been assumed to be important for binding at site 3 of neuronal sodium channels. Additionally, it was found that replacing Phe-7 of β-PMTX with more lipophilic amino non-natural amino acids such as 1-Nal and 2-Nal resulted in a boost in activity, while replacement with a polar residue led to a complete loss of activity. This suggests an essential role of the endogenous Phe-7 residue in mediating the interaction between the venom toxin and the sodium channel.
Subsequent addition of three 5-carbon IPP units to a single 5-carbon DMAPP unit generates the 20-carbon central precursor, geranylgeranyl diphosphate (GGPP). Bicyclization of GGPP by the class II diterpene synthase, ent-clerodienyl diphosphate synthase (SdCPS2), produces a labdanyl diphosphate carbocation, which is subsequently rearranged through a sequence of 1,2-hydride and methyl shifts to form the ent-clerodienyl diphosphate intermediate. SdCPS2 catalyzes the first committed reaction in the biosynthesis of salvinorin A by producing its characteristic clerodane scaffold. A series of oxygenation, acylation and methylation reactions is then required to complete the biosynthesis of salvinorin A.
An opioidergic agent (or drug) is a chemical which directly or indirectly modulate the function of opioid receptors. Opioidergics comprise opioids, as well as allosteric modulators and enzyme affecting agents like enkephalinase inhibitors.
Sources: en.wikipedia.org
Purity is normally expressed as a percentage of total peak area from a chromatographic run. The value depends on the column, gradient and detection wavelength chosen. Results generated under different conditions are therefore not always interchangeable.
Cycling between frozen and thawed states promotes aggregation and can reduce the amount of soluble peptide. Adsorption to container walls also removes material from solution over time. Suppliers generally recommend aliquoting before freezing to limit the number of cycles.
A typical certificate lists lot number, appearance, purity by chromatographic area, identity confirmation and the analytical methods used. Some suppliers add endotoxin or residual solvent results. The document describes the tested lot only and does not extend to other batches.
PT-141 is a laboratory code for bremelanotide, a synthetic peptide that activates melanocortin receptors. It has been developed both as an injectable pharmaceutical product and as a research chemical. The two contexts differ sharply in how identity, purity, and dosing are controlled.